Raymarine RSW-Wired, Руководство по установке

Страница: 14 / 74

• Axiom multifunction display, running LightHouse™ 4 version 4.5 or later.
• Alpha Series display and Axiom multifunction display, running LightHouse™
4 version 4.5 or later.
• i70 or i70s instrument, running software version 3.21 or later.
Displaying mast rotation angle data
In order to display mast rotation angle data, the following Raymarine® devices
must be available on the network:
• Axiom multifunction display, running LightHouse™ 4 version 4.5 or later.
• Vessel heading data from a separate heading sensor is required. Examples
of Raymarine devices that produce vessel heading data include:
– EV-1 (E70537)
– EV-2 (E70097)
– AR200 (E70096)
Additional data requirements
Some of the wind transducer’s data output and calculations are dependent
on the transducer receiving the following data from other devices.
• SOG (Speed Over Ground) and COG (Course Over Ground) — this data,
typically provided by a GNSS (GPS) receiver, is required for a networked
multifunction display / chartplotter to output Ground wind data.
• Vessel heading — this data, usually provided by a heading sensor or
autopilot system, is required for a networked multifunction display /
chartplotter to output Mast rotation angle data.
• STW (Speed Through Water) — this data, provided by a speed transducer,
is required for a networked multifunction display / chartplotter to output
accurate True Wind and Back-calculated Apparent Wind data. Without a
speed transducer, the data will be approximated only, and is therefore
less accurate.
Note:
• For a list of available speed transducers and heading sensors, refer to:
p.59 — Spares and accessories
• For a list of supported NMEA 2000 PGNs refer to:
p.67 — Supported NMEA 2000 PGNs
3.3 System example
The system example below shows devices that can be connected in
conjunction with the Smart Wind transducer to a multifunction display /
chartplotter in order to display and calculate accurate wind data.
1. RSW-Wired Smart Wind transducer.
2. GNSS (GPS) receiver (e.g.: RS150).
3. Heading sensor (e.g.: EV-1).
4. NMEA 2000 gateway (supplied).
5. i70s instrument display, running software version 3.21 or later.
6. Alpha series displays.
7. SeaTalkng ® 12 V dc power connection.
8. Speed transducer (e.g.: DST800).
14