Raymarine LIGHTHOUSE 3, Инструкции по продвинутой эксплуатации

Страница: 98 / 450

• Hydraulic Pump Type 3
Important:
If your drive type is not listed, contact your Raymarine dealer for advice.
2. Select Continue .
Drive type selection is also available when the autopilot is in standby, from the Advanced settings
menu: Homescreen > Settings > Autopilot > Pilot set-up > Drive type .
Aligning the rudder
For systems that have a rudder reference transducer fitted, Rudder alignment is included in the
dockside wizard and comes after drive type selection. For systems without a rudder reference
transducer fitted rudder alignment is not required.
• The following procedure only applies to vessels with a rudder reference
transducer.
1. Select Continue .
2. Center the rudder and select OK .
3. Put the rudder all the way to port and press OK .
4. Put the rudder all the way to starboard and press OK .
5. Center the rudder and select OK .
6. Select Continue when the task complete message is displayed to progress to the rudder limit
page.
Setting the rudder limit
Rudder limit setting is included in the dockside wizard and comes after rudder alignment or drive
selection depending on whether a rudder reference transducer is fitted.
• For vessels without a rudder reference transducer
• Rudder limit are set to 30 degrees and can be adjusted as required.
• For vessels with a rudder reference transducer
• The rudder alignment process establishes the rudder limit. The rudder limit
will be displayed with a message confirming that the rudder limit has been
updated.
• If required, the limit can be adjusted.
1. Ensure that the rudder limit is sufficient to prevent the steering mechanism impacting the end
stops and placing the steering system under unnecessary load. If required adjust the limit by
selecting the rudder limit value box.
Important:
It is recommended that the limit is set to approximately 5 degrees less then the maximum rudder
angle.
2. Select Continue to move to the next step.
Note:
The rudder limit can be adjusted when the autopilot is in standby, from the Pilot set-up menu:
Homescreen > Settings > Autopilot > Pilot set-up > Rudder Limit .
98