
Power cable extension
The product is supplied with a power cable, which
can be extended if required.
• The power cable for each unit in your system
should be run as a separate, single length of
2-wire cable from the unit to the vessel's battery or
distribution panel.
• Raymarine recommends a
minimum
wire gauge
of 18AWG (0.82 mm
2
) for any length of cable
extension.
• For all lengths of extension to the power cable,
ensure there is a continuous
minimum
voltage
at the product’s power connector of 10.8 V with a
fully flat battery at 11 V.
Important:
Be aware that some products in
your system (such as sonar modules) can create
voltage peaks at certain times, which may impact
the voltage available to other products during the
peaks.
Grounding — Dedicated drain wire
The power cable supplied with this product includes
a dedicated shield (drain) wire for connection to a
vessel's RF ground point.
It is important that an effective RF ground is
connected to the system. A single ground point
should be used for all equipment. The unit can be
grounded by connecting the shield (drain) wire of
the power cable to the vessel's RF ground point.
On vessels without an RF ground system the shield
(drain) wire should be connected directly to the
negative battery terminal.
The dc power system should be either:
• Negative grounded, with the negative battery
terminal connected to the vessel's ground.
•
Floating, with neither battery terminal connected
to the vessel's ground
Warning: Product grounding
Before applying power to this product,
ensure it has been correctly grounded, in
accordance with the instructions provided.
Warning: Positive ground systems
Do not connect this unit to a system which
has positive grounding.
4.5 SeaTalk
ng®
connections
The
MFD
can connect to a
SeaTalk
ng®
backbone.
SeaTalk
ng®
can be used to communicate with:
•
SeaTalk
ng®
instruments
• SeaTalk
SeaTalk
ng®
autopilots
•
SeaTalk
equipment via the optional
SeaTalk
to
SeaTalk
ng®
converter
•
NMEA 2000
equipment via optional
DeviceNet
adaptor cables
Typical SeaTalk
ng®
system
00
D12176-5
12 V / 24 V dc
1
2
6
9
1
0
8
7
3
4
5
1.
SeaTalk
ng®
instrument
2.
SeaTalk
ng®
pilot control head
3.
iTC-5 converter
4.
Wind transducer
5.
MFD
6.
Power supply
7.
SeaTalk
ng®
autopilot
8.
iTC-5 converter
9.
Depth transducer
10. Speed transducer
For details of SeaTalk
ng
cabling please refer to
Chapter 12 Spares and accessories
.
SeaTalk
ng
power requirements
The SeaTalk
ng
bus requires a 12 V power supply.
Power may be provided from:
• Raymarine equipment with a regulated 12 V power
supply (for example, a SmartPilot SPX course
computer); or:
36
eS Series installation instructions
Содержание eS Series
