Raymarine E70061, Инструкция по установке и эксплуатации

Страница: 37 / 62

Using Tack and VMG buttons
Tack True/App Display VMG
TACK
VMG
KTS
1
2
D 12550-1
During normal operation:
1. Press the VMG button to show the VMG page on the digital
display.
Note: VMG information is only available when vessel speed
information is available.
2. Press the Tack button to show the Tack page on the digital
display.
Note: Tack information is only available when vessel heading
and speed information is available.
Switching between true and apparent wind
information
You can switch the unit between displaying True or Apparent
wind information.
D12551-1
1
2
During normal operation:
1. Press the True / App button to switch between true or
apparent wind information.
• In True mode the indicator shown in 1 above will be
displayed.
• In Apparent mode the indicator shown in 2 above will be
displayed.
7.3 Group illumination
Group illumination is used to synchronizes and control the
backlighting level of multiple units assigned to the same group.
The unit can participate in shared illumination via a SeaTalk
network or group illumination via a SeaTalk
ng network.
When connected on a SeaTalk network all compatible units will
share their backlight level (when 1 unit's backlighting level is
adjusted all other units backlight level will also change).
When connected on a SeaTalk ng network the unit can participate
in group illumination and be assigned to a group of units which
will share their backlighting levels. Available groups are as
follows:
• Helm 1
• Helm 2
• Cockpit
• Flybridge
• Mast
• grP1 to grP5
When assigned to a group, when the backlighting of 1 unit is
adjusted the backlighting level of all units assigned to the same
group will also change.
Assigning the unit to a group
To assign the unit as part of a group so that it can participate in
group illumination follow the steps below.
During normal operation:
1. Press and hold the Display (Power) and True / app buttons
simultaneously for 6 seconds.
The Group brightness entry page is displayed.
Note: The Group brightness entry page is a temporary
page and will time-out to the previous page after 8 seconds.
2. Press the Display (Power) button to display the Group page.
3. Use the VMG or Tack buttons to select the group the unit
will be assigned to.
Using your display
37