Raymarine Autohelm 2000, Руководство пользователя

Страница: 13 / 18

OPERATING MODE INDICATION
The operating mode of
Aulohelm
2000 is indicated by a flashing LED as
OPERATING MODE
LED CODE
STANDBY
Enables
lo be
positioned over the tiller pin and
1 I I
provides power
AUTO
Autopilot steers
maintain
compass heading.
- -
Aulopilol sleers lo maintain
apparent wind angle.
mode is also confirmed by a single
beep tone
every 30
seconds.
Hand Held Control Unit
An optional hand held conlrol unit can be
plugged control
to
provide
(Cat No. 2076)
full course change capability from
anywhere on board. The
duplicates
the main control units four course
change keys and may be used in
Stand by and Auto modes. The
operalion of the main conlrol is
unchanged when hand held conlrof
unit is
Radio Navigation Interface
cross
lo NMEA
No
or II
lo
I II
I
of
or
I
IO
FUNCTIONAL TEST
PROCEDURE
you
should carry out the following
lo familiarise yourself syslem
before sea
Plug Aulohelm 2000 power
and switch on
supply. The unit will emit a short beep
Lone lo indicale
it is and
LED will flash to indicate Stand by
mode.
Ensure the mounting pin is engaged in
the socket. Using four course control
keys to extend or
end over tiller pin. The
unit will a short beep lone on each
press of a key lo confirm valid
Place end on pin,
and press key. The should
move lo II the litter moves to
the changeover switch is
set and be adjusted as
described on page 3.
Press Auto lo place the
under compass control. The LED will be
tit constantly to indicale that
unit is in
Auto mode. If yacht is swinging
mooring, you will see small
variations in heading cause the to
apply action lo the rudder.
Press Stand by lo relurn lo
Stand by mode.
Rudder Control Adjustment
sea lrials rudder
conlrol be lo
selling shown below.
This will provide control
for sea trials and may, if necessary,
be fine later (see page 25).
20
21