Rayco C275, Инструкция оператора, обслуживания и технического обслуживания

Страница: 13 / 94

C275 Operation & Service Manual
800.392.2686
13
Safety
When the engine is at operating temperature, the engine
coolant is hot. The coolant is also under pressure. The
radiator and all lines to the heaters or to the engine contain
hot coolant.
Any contact with hot coolant or with steam can cause severe
burns. Allow cooling system components to cool before the
cooling system is drained.
Check the coolant level only after the engine has been stopped.
Ensure that the filler cap is cool before removing the filler
cap. The filler cap must be cool enough to touch with a bare
hand. Remove the filler cap slowly in order to relieve pressure.
Cooling system conditioner contains alkali. Alkali can cause
personal injury. Do not allow alkali to contact the skin, the
eyes or the mouth.
Oils
Hot oil and hot components can cause personal injury. Do
not allow hot oil to contact the skin. Also, do not allow hot
components to contact the skin.
Remove the hydraulic tank filler cap only after the engine
has been stopped. The filler cap must be cool enough to
touch with a bare hand. Follow the standard procedure in
this manual in order to remove the hydraulic tank filler cap.
Batteries
Electrolyte is an acid. Electrolyte can cause personal injury.
Do not allow electrolyte to contact the skin or the eyes.
Always wear protective glasses for servicing batteries. Wash
hands after touching the batteries and connectors. Use of
gloves is recommended.
Fire Prevention and Explosion Prevention
All fuels, most lubricants, and some coolant mixtures are
flammable.
Flammable fluids that are leaking or spilled onto hot surfaces
or onto electrical components can cause a fire. Fire may
cause personal injury and property damage.
Remove all flammable materials such as fuel, oil, and debris
from the machine. Do not allow any flammable materials
to accumulate on the machine. Serious personal injury can
occur when fuel or oil is spilled on yourself or your clothes,
which can ignite.
Store fuels and lubricants in properly marked containers away
from unauthorized persons. Store oily rags and any flammable
materials in protective containers. Do not smoke in areas
that are used for storing flammable materials.
Do not operate the machine near any flame.
Extinguish all cigarettes, cigars, pipes and other sources
of ignition.
Exhaust shields (if equipped) protect hot exhaust components
from oil spray or fuel spray in case of a break in a line, in a
hose, or in a seal. Exhaust shields must be installed correctly.
Do not weld on lines or on tanks that contain flammable fluids.
Do not flame cut lines or tanks that contain flammable fluid.
Clean any such lines or tanks thoroughly with a nonflammable
solvent prior to welding or flame cutting. Check all electrical
wires daily. Repair any wires that are loose or frayed before
you operate the machine. Clean all electrical connections
and tighten all electrical connections.
Dust that is generated from repairing nonmetallic hoods or
non metallic fenders can be flammable and/or explosive.
Repair such components in a well ventilated area away from
open flames or sparks.
Inspect all lines and hoses for wear or for deterioration. The
hoses must be properly routed. The lines and the hoses
must have adequate support and secure clamps. Tighten
all connections to the recommended torque. Leaks can
cause fires.
Use caution when you are refueling a machine. Do not smoke
while you are refueling a machine. Do not refuel a machine
near open flames or sparks. Always stop the engine before
refueling. Fill the fuel tank outdoors.