Raychem nVent HWAT-ECO V5 (EU), Инструкция по установке, эксплуатации и обслуживанию

Страница: 13 / 24

EN
SETTINGS
BOILER
ECONOMY TEMP
AT 17:00
INFO, RESET, SERVICE, TEST....
CABLE TYPE, PIPE DAIMETER,...
COUNTRY, LANGUAGES, UNITS,...
APPARTMENT, MAINTAIN, ECONOMY,....
SETTING
SYSTEM
HEATING CABLE & PIPE
GENERAL SETTINGS
WATER TEMP. & PROGRAM
INFO
TEST PROGRAM
RESET
SERVICE
STATUS
SYSTEM
SELECT COUNTRY
SELECT DATE
SELECT TIME
SELECT ALARM
SELECT SAVING TIME
14 : 17
14 : 17
14 : 17
SELECT WATER TEMPERATURE
SELECT PROGRAM
PROGRAM TIMER
SELECT CABLE TYPE
SELECT PIPE DIAMETER
SELECT INSULATION THICKNESS
SELECT AMBIENT TEMPERATURE
SELECT BOILER SENSOR
SELECT BOILER CUT-OFF TEMPS.
HWAT-M
DN 25
40 MM
20°C
ON
35/85°C
HEATING CABLE & PIPE
SYSTEM
NOW
BOILER
ECONOMY TEMP
AT 17:00
NEXT
INFO, RESET, SERVICE, TEST....
CABLE TYPE, PIPE DAIMETER,...
COUNTRY, LANGUAGES, UNITS,...
APPARTMENT, MAINTAIN, ECONOMY,....
SETTING
SYSTEM
HEATING CABLE & PIPE
GENERAL SETTINGS
WATER TEMP. & PROGRAM
INFO
TEST PROGRAM
RESET
SERVICE
STATUS
SYSTEM
SELECT LANGUAGE
SELECT COUNTRY
SELECT DATE
SELECT TIME
SELECT ALARM
SELECT SAVING
14 : 17
14 : 17
14 : 17
SELECT WATER
SELECT PROGR
PROGRAM TIM
SELECT CABLE TYPE
SELECT PIPE DIAMETER
SELECT INSULATION THICKNESS
SELECT AMBIENT TEMPERATURE
SELECT BOILER SENSOR
SELECT BOILER CUT-OFF TEMPS.
HWAT-M
DN 25
40 MM
20°C
ON
35/85°C
HEATING CABLE & PIPE
Info
General info about the unit, name, commissioning date,
firmware version, nVent contact info per country.
Test
Programme
The test programme runs for 30 minutes, during which
all parameters will be ignored to check the heating
cable and the connection on site. You can stop the test
programme at any time.
Reset
Select “Yes” to activate the Quick install menu and return
all settings to factory settings.
Quick start process restarts automatically.
Service Access for nVent SERVICE TEAM
Status
Info on current status of the control unit:
Pipe temperature
Boiler temperature
Maintain temperature
Supply voltage
Duty cycle
Power output
Max power output
Load current
Key lock
When key lock is “On”, the setup and timer menus are
protected by password. To unlock the unit, enter the
predefined password ( 3000 ). The unit will automatically
lock itself after 10 mins of inactivity or when Lock “On”
key is pressed. To deactivate the Key lock, press “OFF”.
nVent.com/RAYCHEM
|
13