Rayburn 680KCD C, Руководство по установке

Страница: 9 / 36

The oil supply connection between the storage tank and
the oil pipe should be run in copper pipe with a minimum
diameter of 10mm. Galvanised pipes and fittings should
not be used. Annealed copper pipe is preferred with a
flare type manipulative fittings. Capillary fittings with soft
solder should not be used. Steel pipes should be joined
using taper threads.
All pipework and fittings must be completely air tight. Only
oil resistant compounds and PTFE tape should be used
when making joints. Pipework must be protected against
damage whether fitted above or below ground.
The size and arrangement of pipework will depend upon
the distance and height of the oil storage tank in relation
to the oil pump inlet.
The oil line from the storage tank to the appliance
must be fitted with a remote acting OFTEC approved
fire valve operating at 150°F (65°C), fitted with an
appropriate length of capillary to enable the valve
body to be located externally at the point where the
oil line enters the building.
The 5-10 micron oil filter supplied with the appliance must
be fitted in the oil pipe and stop valve must be fitted as
close to the cooker as possible in an accessible position.
A flexible pipe connection, approximately 1000mm long,
is supplied to fit between the oil supply pipe and the oil
pump for ease of burner removal. This must be contained
within the appliance.
The minimum recommended oil tank size is 1400 litres
and the code of practice governing its installation are
covered by BS: 5420: Part 1. Mild Steel Tanks should be
to BS 799: Part 5 and plastic tanks to OFTEC Standard
OFS T100.
Site requirements
9
OIL PIPE LINE OIL STORAGE
GRAVITY SINGLE FEED
PIPE SYSTEM
Fig. 3 - Rayburn 680KCD C/F shown DESN 516267 A