Manual No. 016-5032-004
19
Cab Component Installation
Install the Foot Switch
FIGURE 3.
Foot Switch Installed
1.
Select a suitable location for the foot switch (P/N 063-0172-470) to be installed.
Note:
The foot switch should be installed in a location where the operator has easy access to it and is
able to fully press the pedal.
2.
Using the holes in the foot switch as a template, drill holes in the floor of the cab.
3.
Secure the foot switch to the floor by installing the supplied screws in each of the mounting holes.
4.
Locate the ENABLE connector on the node harness (P/N 115-4001-126) and connect it to the foot switch
cable connector.
Install the Valve Harness
1.
From outside the cab, route the 6-pin and 12-pin connectors of the valve harness (P/N 115-4001-104) into
the cab through the opening in the floor at the fuse box.
2.
Plug the 12-pin connector of the valve harness into the VALVE connector of the node harness (P/N 115-
4001-126).
3.
Coil the WAS cable connector and store it in the in the fuse box.
Note:
The WAS connection is not used in the SmarTrax system.
4.
Route the valve harness under the cab and toward the PVE.
Содержание SmarTrax Case IH Steiger Series
