Raven SC1, Руководство по калибровке и эксплуатации, Страница: 25 / 79

Initial Implement Calibration: Initial Implement Calibration 21
INITIAL IMPLEMENT CALIBRATION
FIGURE 22. Desired Furrow Width Page
12. Select the Next button.
FIGURE 23. Desired Furrow Width Page
13. Enable the Plough Direction Sensor option to allow the system to detect and use the plough direction for
future references.
14. Enter the number of plough bodies in the Number of Bodies field.
NOTE: The system will use the entered furrow widths and this value to calculate the overall guidance width of
the plough.
15. Use the Desired Furrow Width field to set the desired position for the plough bodies during operation. This
sets the position which the system will attempt to maintain while operating the plough steering system during
guidance operation.
16. Use the Minimum Desired Furrow Width to set the lowest or narrowest physical furrow position which the
system will allow during operation.
17. Use the Maximum Desired Furrow Width to set the highest or widest physical furrow position which the
system will allow during operation.
18. Confirm the settings shown on this page and select the Next button.
19. Raise the implement.