Raven DCS 300, Инструкция по установке и обслуживанию

Страница: 24 / 27

20
8) 8) 8) 8) 8) Verify that the boom valve operates and that no nozzles are plugged.
9) 9)
9) 9) 9) To assure motorized Control Valve is fully closed, enter 999.9 into LIQ CAL, 10 into
METER CAL, 10 into GRAN CAL, and 1000 into SELF TEST.
10) 10) 10) 10) 10) Adjust agitator line hand valve for desired agitation.
11) 11)
11) 11) 11) Close the main line hand valve, if necessary, to set the desired maximum operating
pressure. Maximum pressure should be approximately 10 psi [70 kPa] above normal
pre-wetting pressure.
EXAMPLE: EXAMPLE: EXAMPLE: EXAMPLE: EXAMPLE: If normal pre-wetting pressure is 30 psi [210kPa], set maximum pressure
at approximately 40 psi [280 kPa].
12) 12) 12) 12) 12) To assure motorized Control Valve is fully open, enter 0 into METER CAL.
13) 13) 13) 13) 13) Close by-pass #1 hand valve to set the desired minimum operating pressure. Minimum
pressure should be approximately one half the normal pre-wetting pressure.
EXAMPLE: EXAMPLE:
EXAMPLE: EXAMPLE: EXAMPLE: if normal spraying pressure is 30 psi [210kPa], set minimum pressure at
approximately 15 psi [105 kPa].
14) 14) 14) 14) 14) Verify maximum and minimum pressures and LIQ/GRAN rate by repeating Steps 11 and
13 .
INITIAL SYSTEM ROAD TEST
1) 1) 1) 1) 1) Drive down road at target granular rate with pre-wetting OFF.
2) 2)
2) 2)
2) Turn on spray and place the POWER switch to ON. Increase or decrease speed slowly.
The system should automatically correct to the target LIQ CAL rate.
3) 3) 3) 3) 3) If for any reason the system is unable to correct to the desired LIQ CAL rate, check
for an empty tank, a plugged line, a malfunctioning pump, improper vehicle speed
or a defect in the system.
4) 4) 4) 4) 4) If the system does not appear to be correcting properly, review INITIAL SYSTEM SET-
UP.
5) 5)
5) 5)
5) Verify granular and liquid volume used.