Raven Cruizer, Руководство по эксплуатации

Страница: 6 / 28

4
Initial Startup
The first time that the console is powered up, a Setup Wizard will step through
the initial setup and calibration. The Setup Wizard helps with the configuration
process and is only required the first time the Cruizer is started. Any settings
selected or calibration values entered in the Setup Wizard may be adjusted
at any time via the
Tools Menu . See the Tools Menu section on page 14 for
more information.
1. On the first screen, select the language and display units. Select either
U.S. (inches) or Metric (meters). Touch Next to accept the displayed
settings and to advance to Width Setup Screen.
2. Use the displayed keypad to enter the overall implement, equipment, or
boom width in the units selected on the previous screen. Touch Next
to accept the displayed selection and to advance to the Antenna Position
screen.
Use the Antenna Position screen to set the position of the GPS antenna
with respect to the center of the boom or implement width.
The left side of the Antenna Position screen displays a visual reference of
the location of the boom or implement and DGPS antenna. After the
antenna offsets are programmed, the antenna position display should
show a general representation of the actual machine configuration.
To set the Antenna Position offsets, touch the desired offset value and use
the on-screen keypad to enter the new value.
Note: If the touch screen does not properly power up, refer to the
Troubleshooting section on page 21.
Current
Offset Units
Current
Offset Values
Boom/Implement
Location Selection
Live Antenna
Position Display