36
3. To add to the plan, select Add Baseline or Guidance line.
4. If this baseline will be a headland, check the Headland checkbox.
5. Enter a Swath Count. For headlands this may only be a few swaths. For using the
baseline for the entire field, this will be as many lines as necessary to complete
the field.
6. Select if the offset Direction will be inside or outside of the baseline.
7. Enter an Offset measurement. This will offset the tramline from the edge of the
field boundary.
8. Enter an Extra Zone Width measurement. This will offset the tramlines within the
field from each other by the entered width.
9. Select Apply Tramlines. This will apply the tramline settings created earlier.
10. Edit any Additional Tramlines.
11. Select Done.
12. Apply the Region Settings to all the desired baselines.
NOTE:
The region settings will default to the most recent Region Setting
Configuration. As a rule, apply all the same types of offsets in order to
minimize reconfiguration.
13. When starting a job, select the desired operation plan.
14. During a job, select the Operation Planning widget to access the settings. Any
settings updated within the job will be saved and applied to the plan. Any nudges
or settings adjusted on the run screen will not be saved with the plan.
Headland
Passes
Enter the number of swaths needed for turn around.
Guidance lines will be created based on this setting.
Offset
This is the extra space wanted between the baseline and the
first swath. This space will be a non-covered area around the
edge of the field.
