016-0236-001 Rev. E
35
SENSOR INSTALLATION
LEFT AND RIGHT TILT SENSOR INSTALLATION
90’ AND 100’ BOOM
1. Identify a mounting location on the boom frame for the tilt sensor assembly which is labeled “RIGHT TILT” for
the right boom and “LEFT TILT” for the left boom. The mounting position should be in a location near the
boom pivot point and, when installed, the tilt bracket sensor arm should be on the back of the boom.
FIGURE 17. Tilt Sensor Bracket Installed (Right Boom Shown)
2. Loosely install the tilt sensor assembly to the angled boom structure using two provided U-bolts and nuts.
FIGURE 18. Rod End Bracket Installation
3. Slide the rod end bracket over the threaded end of the 1” bolt.
4. Install and tighten the new nut on the threaded end of the 1” bolt.
NOTE:
Do not tighten or loosen the existing bolt or nut to which the rod end bracket and new nut are
mounted.
Tilt Sensor
Assembly
Tilt Sensor Arm
Rod End Bracket
Rod End
Bracket
New Nut