C
HAPTER
4
28
AutoBoom® XRT Installation Manual for Case IH Patriot 3xx0/44x0 and Trident 5550 (MY 2017-2021)
120’, 132’, AND 135’ ALUMINUM BOOM
1. The table below provides the approximate mounting locations for various boom widths. The information on
this table is for reference only. If there is interference or other issues with these mounting locations, mount the
sensors as close to these locations as possible.
TABLE 2.
Sensor Mounting Location
NOTE:
The numbers in the table above are the approximate distance. As a rule, the sensor should be
mounted half way between two spray nozzles to minimize potential drift interference.
2. Install the radar sensors (P/N 063-0173-962) on the sensor mounting brackets (P/N 107-0235-001) using two
1/4”-20 x 5/8” Phillips pan head bolts (P/N 311-0050-255) and two 1/4”-20 nylon locking nuts per sensor (P/N
312-4000-164).
NOTE:
Install two of the sensors in one orientation and three in the other orientation on the bracket so, when
installed, the sensor connection is facing towards the center of the machine.
FIGURE 5. Sensor Installed on Mounting Bracket
3. Mount the boom sensor assemblies on the inside of the boom frame using two 1/4”-20 nylon lock nuts and two
1/4”-20 bolts.
WARNING
The machine must remain stationary and
switched off, with the boom unfolded and
supported, during installation or maintenance.
Boom
Width
Inner Sensor Mounting
Distance from Boom
Pivot Point
Optional Mid Sensor
Mounting Distance
from Boom Pivot Point
Outer Sensor Mounting
Distance from Boom
Pivot Point
120’
330”
630”
132’
304”
503”
701”
135’
331”
531”
731”