Page 24 of 37
INSTRUCTION, USE AND
MAINTENANCE MANUAL
GB
7. Rotate clockwise until tyre complete assembly (see
Fig.
_
42
).
NOTE:
For the mounting of very difficult wheels, use
the extension of the bead depressor (
Fig.
_
42
ref.
_
1
) (optional).
1
Fig. 42
8. When the operations have been completed move all
the tools in rest position.
12.7 Tyre inflation with machine without
tubeless inflation
Connect the inflation device to the tyre valve and in-
flate the same tyre using the pedal provided (
Fig. 14
ref. B
).
A SAFETY DEVICE IS PRESENT
FOR THE ADJUSTMENT OF THE
MAXIMUM PRESSURE OF THE
SUPPLIED AIR (4,2 ± 0,2 BAR /
60 PSI).
Well lubricated beads and rims make the beading in
and inflation much safer and easier.
In case the beads are not seated at 4.2 ± 0.2 bar,
release all the air from the wheel, remove it from the
tyre changer and put it in a safety cage to complete
the inflation procedure.
12.8 Tyre inflation with machine with tube-
less inflation
Some types of tyres can be difficultly inflated if the
beads are not in contact with the rim. The tubeless
inflation device supplies a jet of high-pressure air from
the nozzle, which encourages the correct positioning
of the bead against the rim, and therefore normal
inflation.
In order to carry out the inflation of the tyre follow
these indications:
• Connect the inflation terminal to the valve of the tyre.
• Press the nozzle against the rim edge.
• Lift the lower bead while the pedal, is pushed at its
second stage, supplying that way the air jet required
for bead insertion.
• Continue to inflate the tyre up to the required pres-
sure keeping the provided pedal pressed.
IN ORDER TO ALLOW THE AIR
JET TO BREAK BOTH BEADS,
DO NOT KEEP THE BEAD LIFTED
FORCING IT.
12.9 Special use of the bead-breaker
In addition to its use during mounting and demounting,
the bead-breaker roll can also be used for matching
the tyre to the rim. To conduct this operation carry out
the following instructions.
• Clamp the tyre between the bead breaker roll.
• Turn the motor clockwise until the reference point
on the tyre coincides with the reference point on the
rim (usually the valve) (see
Fig.
_
43
).
Fig. 43
13.0 ROUTINE MAINTENANCE
BEFORE CARRYING OUT ANY ROU-
TINE MAINTENANCE PROCEDURE,
DISCONNECT THE MACHINE
FROM ITS POWER SUPPLY SOURC-
ES, TAKING SPECIAL CARE OF
THE ELECTRICAL PLUG/SOCKET
CONNECTION.
To guarantee the efficiency and correct functioning
of the machine, it is essential to carry out daily or
weekly cleaning and weekly routine maintenance, as
described below.
Cleaning and routine maintenance must be conducted
by authorized personnel and according to the instruc-
tions given below.
• Disconnect the mains power supply before starting
any cleaning or routine maintenance operations.
G1180.30SLIM - G1180.30SLIMIT
7105-M002-10_R
RAVAGLIOLI S.p.A.
