Page 11 of 37
INSTRUCTION, USE AND
MAINTENANCE MANUAL
GB
8.0 WORKING ENVIRONMENT CONDI-
TIONS
The machine must be operated under proper condi-
tions as follows:
• temperature: 0° + 55° C
• relative humidity 30 - 95% (dew-free)
atmospheric pressure: 860 - 1060 hPa (mbar).
The use of the machine in ambient conditions other
than those specified above is only allowed after prior
agreement with and approval of the manufacturer.
8.1
Working position
In
Figure 4
it's possible to define work positions
A
and
B
which will be referred to during the description of
the machine operating phases.
Position
A
is the main position for wheel fitting and
removal with the mandrel, while position
B
is ideal to
follow tyre inflation operations.
Working in these positions allows better precision and
speed during operating phases as well as greater safety
for the operator.
8.2
Working area
Fig.
_
4
~ 1000
~ 1000
3090
2310
~ 1000
B
A
USE THE MACHINE IN A DRY AND AD-
EQUATELY LIT PLACE, POSSIBLY INDOORS
OR ANYWAY IN A ROOFED AREA, THIS PLACE
MUST BE IN COMPLIANCE WITH APPLICABLE
SAFETY REGULATIONS.
The location of the machine requires a usable space as
indicated in
Figure 4
. The positioning of the machine
must be according to the distances shown. From the
control position the operator is able to observe all
the machine and surrounding area. He must prevent
unauthorized personnel or objects that could be dan-
gerous from entering the area. The machine must be
fixed on a flat floor surface, preferably of cement or
tiled. Avoid yielding or irregular surfaces. The base
floor must be able to support the loads transmitted
during operation. This surface must have a capacity
load of at least 500 kg/m².
The depth of the solid floor must be sufficient to guar-
antee that the anchoring bolts hold.
8.3 Lighting
The machine does not require its own lighting for
normal working operations. However, it must be used
in an adequately lit environment.
In case of poor lighting use lamps having total power
800/1200 Watt.
9.0 MACHINE ASSEMBLY
After having freed the various components from the
packing check that they are complete, and that there
are no anomalies, then comply with the following in-
structions for the assembly of the components making
use of the attached series of illustrations.
9.1
Anchoring system
The packed machine is fixed to the support pallet
through the holes prearranged on the frame. Such
holes can be used also to fix the machine to the ground,
through floor anchor small blocks (excluded from sup-
ply). Before carrying out the definitive fixing, check that
all the anchor points are laid down flat and correctly
in contact with the fixing surface itself. If not so, insert
shimming profiles between the machine and the fixing
lower surface, as indicated in
Fig.
5
.
b
a
X
X
X
X
X
1
a
=641 mm
b
=440 mm
Fig.
_
5
7105-M002-10_R
RAVAGLIOLI S.p.A.
G1180.30SLIM - G1180.30SLIMIT
