7105-M007-0
INSTRUCTIONS FOR
ASSEMBLY AND USE
Page 6 of 19
GB
G1000A99NP - G800A121NP
4.0 GENERAL SAFETY RULES
• Any tampering with or modification to the device not
previously authorized by the manufacturer exempts
the latter from all responsibility for damage caused
by or derived from said actions.
• Removing of or tampering with the safety devices or
with the warning signals placed on the machine leads
to serious dangers and represents a transgression of
European safety rules.
• Use of the machine is only permitted in places free
from
explosion
or
fire
hazard and in
dry places
under cover
.
• Original spare parts and accessories should be used.
THE MANUFACTURER DENIES
ANY RESPONSIBILITY IN CASE
OF DAMAGES CAUSED BY UNAU-
THORIZED MODIFICATIONS OR
BY THE USE OF NON ORIGINAL
COMPONENTS OR EQUIPMENT.
• Installation must be conducted only by qualified
personnel exactly according to the instructions that
are given below.
• Ensure that there are no dangerous situations dur
-
ing the machine operating manoeuvres. Immediately
stop the lifting device if it miss-functions and contact
the assistance service of an authorized dealer.
• In emergency situations and before carrying out any
maintenance or repairs, disconnect all supplies to
the device by shutting off the pneumatic supply.
• Ensure that the work area around the device is free
of potentially dangerous objects and that there is no
oil since this could damage the tyre. Oil on the floor
is also a potential danger for the operator.
OPERATORS MUST WEAR SUIT-
ABLE WORK CLOTHES, PROTEC-
TIVE GLASSES AND GLOVES,
AGAINST THE DANGER FROM
THE SPRAYING OF DANGEROUS
DUST, AND POSSIBLY LOWER
BACK SUPPORTS FOR THE LIFT-
ING OF HEAVY PARTS. DANGLING
OBJECTS LIKE BRACELETS MUST
NOT BE WORN, AND LONG HAIR
MUST BE TIED UP. FOOTWEAR
SHOULD BE ADEQUATE FOR THE
TYPE OF OPERATIONS TO BE CAR-
RIED OUT.
• The machine handles and operating grips must be
kept clean and free from oil.
3.0 SAFETY DEVICES
PERIODICALLY, AT LEAST MONTH-
LY, CHECK THE INTEGRITY AND
THE FUNCTIONALITY OF THE
SAFETY AND PROTECTION DE-
VICES ON THE DEVICE.
• Fixed guards and shelters.
On the machine are present some permanent protec
-
tions that are supposed to avoid potential risks of
getting crushed, cut or pressed.
• Man-operated control
(
Fig.
_
1 ref.
_
1
) makes the
pedal support stop in position after the release of
the drive pedal. This is to make sure that the device
cannot move without the operator’s assent.
•
A
slot
(
Fig.
_
1 ref.
_
2
) located on the lifting plate al
-
lows a partial free travel in return line next to the
floor, avoiding the risk of possible crushing of the foot
in between the pedal support and the floor.
Fig.
_
1
3.1
Residual risks
The device was subjected to a complete analysis of
risks according to reference standard EN ISO 12100.
Risks are as reduced as possible in relation with tech
-
nology and product functionality.
This manual stresses possible residual risks, also
highlighted in pictograms on the present manual and
adhesive warning signals placed on the device: their
location is represented in “PLATE LOCATION ON MA
-
CHINETABLE” on page 3.
