QuickLock Operator Manual
16
QuickLock Operator Manual
– Version 15.07.01
2.4.7. Centering the rubber gasket
Center the gasket on the sleeve so that the edge
of the rubber is at least 0.2-
0.4” (5–10 mm)
behind the edge of the sleeve, or on beveled
sleeves behind the edge of the beveled end.
1) 0.2-
0.4” (5-10 mm)
2) 0.2-0.4
” (5-10 mm)
2.4.8. Affixing the rubber gasket
To stop the rubber gasket from shifting on the
steel sleeve during transportation to the damaged
area, affix the gasket to the sleeve with a spot of
superglue above the locks on both ends (@ 12
o’clock), as well as opposite both sides of the
stainless steel sleeve (
@ 6 o’clock) using
superglue.
Glue at four locations with approx. ½ inch strip of
glue at each spot.
Note
: Do not allow glue to drip onto the metal
overlap, because it will stick and prevent the
sleeve from opening.
Note
: If the rubber gasket is not properly affixed,
there is a risk that it might unfold and bunch up at
a constricted point in the pipe without you
noticing.
