Rauch QUANTRON-A AXIS-M 20 Q, Инструкция по эксплуатации

Страница: 106 / 116

Alarm messages and possible causes 6
100
12 Transmission fault. No
RS232 connection An error has occurred during data transmis-
sion to the control unit.
The data have not been transmitted.
14 Error by setting TELIMAT. Alarm for the TELIMAT sensor.
This error message is displayed if the TELI-
MAT status cannot be detected for more
than 5 seconds.
15 Memory full. Delete one pri-
vate fertiliser chart. A maximum of 30 fertiliser charts can be
saved.

No additional saving possible
16 Approach drop point
Yes = Start For machines with electrical drop point ac-
tuators: Safety query before the drop point
is automatically approached.

Drop point can be set in the Fertiliser
settings menu.

Fast emptying.
17 Error by setting drop point. The actuator for the drop point setting can-
not reach the target value to which it is to be
moved.

Blockage.

No position feedback.
18 Drop point blocked Actuator overloaded.
19 Defect by setting drop point. Actuator defective.
20 Error on LIN bus participant:
[Name]. Communication problem.

Remove actuator.

Cable breakage.
21 Spreader overloaded! The mineral fertiliser spreader is overloaded.

Too much fertiliser in the hopper
23 Error by setting TELIMAT The TELIMAT setting actuator cannot reach
the target value it is to be moved to.

Blockage.

No position feedback.
24 Error by setting TELIMAT Actuator overloaded.
25 Defect by setting TELIMAT TELIMAT actuator defective.
32 Externally controlled parts
may move. Risk of injury
through squeezing and
shearing!
Direct ALL persons out of the
danger zone. Read the in-
struction manual.
Confirm with ENTER If the machine control unit is activated, com-
ponents may move unexpectedly.

Follow the displayed instructions only if
all risks have been eliminated.
No. Message on display Meaning

Possible cause