Rauch K 51, Инструкция по эксплуатации

Страница: 52 / 64

Maintenance and service 9
46
9.2 Wear parts and screw connections
9.2.1 Checking wear parts
Wear parts are: Spreading vanes , agitator, agitator fingers and bottom of
hopper .
 Check wear parts.
If these parts show visible signs of wear, deformation or holes, any worn parts
must be replaced; otherwise the spreading pattern will not be correct.
The durability of wear parts depends in part on the spreading material used.
9.2.2 Checking the bolted joints
Bolted joints have been tightened to the specified torque and locked at the facto-
ry. Vibrations and shocks, in particular during the initial operating hours, can loos-
en bolted joints.

With new machines, all screw connections are to be checked for their tight
seat after approx. 30 operating hours.
 Check all the bolted joints regularly for tightness, and definitely before the
start of the spreading season.
Some components (e.g. spreader vanes) are mounted with self-locking nuts.
When mounting these components
always use new self-locking nuts.
9.3 Cleaning
We recommend cleaning the machine with a soft jet of water immediately after
every use in order to maintain its value.
The following instructions must be observed for cleaning:
 Only clean oiled machines at washing points fitted with an oil separator.
 When cleaning with high-pressure water, never aim the jet directly at warning
signs or sliding bearings.
After cleaning, we recommend treating the dry machine, especially stainless
steel parts , with an environmentally friendly anti-corrosion agent.