Rauch AXIS-M 30.2, Инструкция по эксплуатации

Страница: 78 / 148

Commissioning 7
70
7.10.2 Correcting the spreading distance
The values in the calibration chart are standard values. If there are deviations in
the fertiliser quality, it may be necessary to correct the setting.
If only minor deviations occur, it is generally sufficient to modify the guiding plate
setting.

To decrease the spreading distance relative to the calibration chart setting:
Change the numeric scale guiding plate position in the direction of the lesser
value .

To increase the spreading distance relative to the calibration chart setting:
Change the numeric scale guiding plate position in the direction of the great-
er value .
If there are greater deviations, move the TELIMAT housing along the alphabetic
scale:

To decrease the spreading distance relative to the calibration chart setting:
Move the TELIMAT on the alphabetic scale towards the smaller character
(according to alphabetic order).

To increase the spreading distance relative to the calibration chart setting:
Move the TELIMAT on the alphabetic scale towards the greater character
(according to alphabetic order).
7.10.3 Instructions for spreading with TELIMAT
The TELIMAT position required for the spreading type from the tractor is set by
means of a single-acting control valve.

Limited border spreading: lower position

Normal spreading: upper position.
NOTICE
Limited border spreading at working widths of 12 - 50m :
For an optimal spreading pattern, it is recommended that the application rate be
reduced
by 20% on the limited border spreading side.
n
CAUTION
Spreading errors caused by the TELIMAT not reaching its end
position
If the TELIMAT is not completely at its end position, you may
encounter spreading errors.
 Make sure that the TELIMAT is always in the specified end
position.
 When switching from boundary spreading to normal spread-
ing, actuate the control valve until the TELIMAT is
com-
pletely in the top end position.
 During extended boundary spreading (depending on the
state of your operating unit), actuate the control valve occa-
sionally to return the TELIMAT to its end position.