Rauch AXIS-M 20.2 EMC, Инструкция по эксплуатации

Страница: 32 / 236

Safety 3
12
AXISAXIS
3.8 Maintenance and repair
Maintenance and service work involves additional hazards that do not occur dur-
ing operation of the machine.

Any maintenance and service work is to be conducted with increased alert-
ness at all times. Work particularly thoroughly and cautiously.
3.8.1 Qualifications of maintenance staff

Welding and work on the electrical and hydraulic systems is to be carried out
by qualified technicians only.
3.8.2 Wear parts

The maintenance and service intervals described in the present operator’s
manual are to be strictly adhered to at all times.

Furthermore, the maintenance and repair intervals of the supplier compo-
nents must also be complied with. See the supplier documentation for the rel-
evant intervals.

We recommend that you have the condition of the machine checked after
each season by your specialist dealer, paying particular attention to its fixing
components, safety-relevant plastic components, hydraulic system, metering
parts and spreader vanes.

Spare parts must at least comply with the technical standards specified by the
manufacturer. The technical standards can be guaranteed by using genuine
spare parts.

Self-locking nuts are designed to be used only once. Always use new self-
locking nuts to fasten components (e.g. when replacing spreading vanes).
3.8.3 Maintenance and service work

Always switch off the tractor engine before all cleaning, maintenance and
service work and when troubleshooting. Wait until all rotating parts of the
machine have come to a standstill.

Make sure that no unauthorised person can start the machine. Remove the
ignition key of the tractor.

Before any maintenance and service work, separate the current supply be-
tween tractor and machine.

Disconnect the power supply before working on the electrical system.

Check that the tractor with the machine is correctly parked. Park the spreader
with an empty hopper on level, solid ground and secure it to prevent it from
moving.

Before carrying out any maintenance and service work, depressurise the hy-
draulic system.

If you must work while the PTO shaft is rotating, make sure that nobody is
near the PTO or the universal drive shaft.