Commissioning
67
7
Correcting the spreading distance
The specifications in the provided assembly manual are standard values. If there
are deviations in the fertiliser quality, it may be necessary to correct the setting.
To
decrease
the spreading distance, move towards the spreading disc.
To
increase
the spreading distance, move away from the spreading disc.
7.8.1
Setting the boundary spreading unit
Boundary spreading operation is prepared according to the
fertiliser type
and
working width
for spreading.
Correcting the spreading distance
The values in the fertiliser chart are standard values. If there are deviations in the
fertiliser quality, it may be necessary to correct the setting.
To
decrease
the spreading distance relative to the fertiliser chart setting:
Decrease
boundary spreading disc speed
.
To
increase
the spreading distance relative to the fertiliser chart setting:
Increase
boundary spreading disc speed
.
To
decrease
the spreading distance relative to the fertiliser chart setting:
Select
earlier drop point
.
To
increase
the spreading distance relative to the calibration chart setting:
Select
later drop point
.
NOTICE
The setting values for boundary spreading can be found in the fertiliser chart.
NOTICE
Boundary spreading at working widths 12 - 50m
:
For an optimal spreading pattern, it is recommended that the material output be
reduced
by 20 %
on the boundary spreading side.
Содержание AXIS H EMC Series
