Rauch AXIS H EMC Series, Инструкция по эксплуатации

Страница: 115 / 132

Maintenance and repair
109
9
9.10 Metering slide adjustment
Check that the metering slides open smoothly before every working season, and
during the season if necessary.
Requirements:

The actuator is disengaged.
Check (e.g. left side of machine):
2. Push the metering slide against the pin, and lock it in this position by tighten-
ing the setscrew.
 The stop on the lower scale plate (metering scale) is positioned at the
scale value 85. If the position is not correct, readjust the scale.
n
WARNING
Danger of crushing and shearing due to components operat-
ed by an external force
When working on power-operated components (adjusting lever,
metering slides), there is a crushing and shearing risk.
Pay attention to the shear point of the metering slide opening and
the metering slide during all adjustment work.
 Switch the tractor motor off.
 Remove the ignition key.
 Disconnect the power supply between the tractor and the
machine.
 Never actuate the hydraulic metering slide during adjust-
ment work.
1. Insert a lower link pin with a
diameter of
28 mm centrally
into the metering opening.
Figure 9.13: Lower link pin in metering open-
ing