Appendix
Page 13
TB1 Relay
SmartRescue System Activation Relay
When an Emergency phone has been activated,
this relay changes state and can be connected to
an alarm panel, strobe, or other notification means.
Programming SmartRescue back to default settings
a. Hold down Red Disconnect and Submaster 1 buttons for 5 seconds
b. Release buttons (you will hear a confirmation tone)
c. Press Phone 2 button, then Red button, then Submaster 2 button, and then the Phone 5 button
d. Press Submaster 2 button, then Submaster 1 button (you will hear a confirmation tone)
Program Emergency Phone(s) to Consolidator Mode (Only Elevator Industry)
Note:
Consolidator mode allows you to have up to (10) SmartPhones on a single telephone line and toggle
between them from an outside call.
Programming Steps
a. Press
Enter
to get into program mode
b. Press
7, Enter
c. For Phone(s) 1-5 press
*, 1-5
Example:
For Phone 1: Press
7, Enter, *, 1
For Phone 2: Press
7, Enter, *, 2
d. For Phone(s) 6-10 press
#, 1-5
Example:
For Phone 6: Press
7, Enter, #, 1
For Phone 7: Press
7, Enter, #, 2
e. To exit program mode, press and hold
Stop
for 2-3 seconds until warble sound
f. Confirm operation by calling the phone number that phone(s) are instaled on; all phones will answer.
To speak to individual phones:
i. For phones 1-5 press
*1, *2, *3, *4, *5
ii. For phones 6-10 press
#1, #2, #3, #4, #5
iii. To speak to all phones press
*0
