690RDPOOLVOIP, 990RDPOOLVOIP, 690SYPOOLVOIP (YELLOW), 990SYPOOLVOIP (YELLOW)
2100-986DIP
Page 4
Installation:
1.
Using the spanner bit, remove the 4 screws holding the front cover in place and remove the cover.
2.
Using a drill bit or knockout set, drill a hole in the bottom of the enclosure large enough for the water tight
connector.
3.
Turn over the back of the enclosure and screw 1 mounting foot onto each mounting hole using the supplied
screws.
4.
Using appropriate mounting screws, screw enclosure to the wall using the other side of the mounting feet.
5.
Run the Ethernet connection from the POE port on the Network Switch into conduit, bring the cable into the
enclosure through the water tight connector, and tighten conduit to connector.
6.
Connect the Ethernet cable to “DATA POWER IN” on POE input of phone. See programming section for phone
programming.
Items Needed:
• POE port on Network Switch
• Drill
• Drill bit or knockout set
• Mounting screws
• #10 spanner bit (provided)
• Conduit with water tight connector
• Screwdriver
• Wire nuts
• Mounting feet (provided)
Items Needed:
• POE port on Network Switch
• Drill
• Metal capable drill bit or knockout set
• Mounting screws
• Wall anchors
• Conduit with water tight connector
• 3/32” Allen wrench (provided)
• Screwdriver
Installation:
1.
After opening door on unit, use the Allen wrench to remove the 4 screws securing the internal plate.
2.
Completely remove the internal plate.
3.
Using a drill bit or knockout set, drill a hole in the bottom of the enclosure large enough for the for the water tight
connector.
Note:
Be sure the hole sits far enough back so it doesn’t interfere with the internal plate when it’s reinstalled.
4.
Using appropriate mounting screws and anchors, screw enclosure to the wall.
5.
Run the Ethernet connection from the POE port on the Network Switch into conduit, bring the cable into the
enclosure through the water tight connector, and tighten conduit to connector.
6.
Connect the Ethernet cable to “DATA POWER IN” on POE input of phone. See programming section for phone
programming.
