Handset Phones
Pool Phones are pre-programmed to call 911. Only perform the following if you want the phone to call somewhere
other than 911. Please choose one of the options below that matches the SIP Extension that the phone is installed
on:
1. Programming Telephone Numbers or Extensions
Note:
When programming, ignore messages or busy tones in the background.
a. Start with phone handset hung up
b. Press and hold
Program
button, lift handset off hook, then release
Program
button
c. Press the
#
key 10 times (you will hear confirmation tones in the handset)
d. Press
3, #,
then the phone number or extension you want the phone to dial
e. Press
*, #
to exit Programming Mode, then hang up the handset
2. Programming Phone to Dial Outside Phone Number
Note:
When programming, ignore messages or busy tones in the background.
a. Start with phone handset hung up
b. Press and hold
Program
button, lift handset off hook, then release
Program
button
c. Press the
#
key 10 times (you will hear confirmation tones in the handset)
d. Press
3, #,
then the access code for an outside line (usually 8 or 9)
e. Press
#, *,
then enter the number to be dialed
f. Press
*, #
to exit Programming Mode, then hang up the handset
Speaker Phones
Pool Phones are pre-programmed to call 911. Only perform the following if you want the phone to call somewhere
other than 911. Please choose one of the options below that matches the SIP Extension that the phone is installed
on:
1. Programming Telephone Numbers or Extensions
a. Press
ENTER
to begin programming
b. Press
1, ENTER, (phone number or extension), STOP
c. Press and hold
STOP
for 3 seconds to exit programming
2. Programming Phone to Dial Outside Phone Number
a. Press
ENTER
to begin programming
b. Press
1, ENTER,
key in access code (usually 8 or 9),
PLAY/PAUSE
, (phone number),
STOP
c. Press and hold
STOP
for 3 seconds to exit programming
RESET Button:
To reset all information entered into the IP Pool Phone, unplug the Ethernet cable from the Ethernet port on the IP
interface board then press and hold the red reset button for 20 seconds.
THIS WILL DEFAULT THE UNIT TO DHCP
(you will no longer be able to log into the device using 192.168.1.160). The IP Pool Phone will have to be connected
to a network capable of handing out DHCP. Plug Ethernet cable back into the Ethernet port on IP interface board. To
log back into the unit, perform one of the following steps:
1.
Set the Network Interface Card of the PC to
Obtain an IP Address Automatically
(see Step 4 under IP Interface
Set-Up). Use a network scanner loaded onto the PC to search for the device on the network (name of device will
display as SPA112 or SPA191). The network scanner should display the address the unit is now using.
2.
Plug an analog telephone into the Phone 1 port on the IP interface board:
a. Lift up the handset on the analog phone and dial
*, *, *, *
b. Dial
110
then
#
(phone will say IP address of unit)
c. Dial
120
then
#
for Subnet Mask
d. Dial
130
then
#
for Gateway
e. Hang up analog phone
Page 6
