Page 3
Mounting
Items Needed:
• Live analog phone line
• Drill
• Drill bit or knockout set
• Biscuit jack (provided with 624POOL & 624MPOOL)
• Mounting screws
• Conduit with water tight connector
• 1/8” Allen wrench (provided)
• Screwdriver
• Mounting feet (provided)
Installation:
1. After opening door on unit, use the Allen wrench to remove the 4 screws securing the internal plate.
2. Completely remove the internal plate.
3. Using a drill bit or knockout set, drill a hole in the bottom of the enclosure large enough for the water tight
connector.
Note:
Be sure the hole sits far enough back so it doesn’t interfere with the internal plate when it’s reinstalled.
4. Turn enclosure over and screw 1 mounting foot onto each mounting hole on the back of the enclosure using
provided screws.
5. Using appropriate mounting screws, screw enclosure to the wall using the other side of the mounting feet.
6. Run telephone line in conduit, bring line into the enclosure through the water tight connector, and tighten conduit
to connector.
7. Connect incoming line to the biscuit jack, then plug the line cord connected to circuit board to the RJ11 jack on the
biscuit jack.
Note:
Do not cut RJ11 jack of supplied line cord and splice phone line onto it.
8. Phone is preset to dial 911. If required to call an alternate number not given to RATH® at time of purchase, please
follow programming instructions on page 6-7. If phone is calling 911, screw internal plate back into place. Unit
is ready for testing. The 624MPOOL is a manual dial phone and will not have a preset number.
Note:
If phone does not have a dial tone when handset is lifted, please reverse polarity of incoming phone line.
624POOL, 624MPOOL, 970POOL
Items Needed:
• Live analog phone line
• Drill
• Drill bit or knockout set
• Biscuit jack
• Mounting screws
• #10 spanner bit (provided)
• Conduit with water tight connector
• Screwdriver
984POOL, 984POOLC1
