Installation:
1. Using the spanner bit, remove the 4 screws holding the front cover in place and remove the cover.
2. Using a drill bit or knockout set, drill a hole in the bottom of the enclosure large enough for the for the water tight
connector.
3. Turn over the back of the enclosure and screw 1 mounting foot onto each mounting hole using the supplied
screws.
4. Run telephone line in conduit, bring line into the enclosure through the water tight connector, and tighten conduit
to connector.
5. Connect incoming line to RJ11 connector and plug into RJ11 jack on board. Or, obtain a biscuit jack, terminate the
incoming line to the biscuit jack and plug the included phone line to the RJ11 connector on the biscuit jack.
Note:
Do not cut RJ11 jack of supplied line cord and splice phone line onto it.
6. Phone is preset to dial 911. If required to call an alternate number not given to RATH® at time of purchase, please
follow programming instructions on page 6-7. If phone is calling 911, screw internal plate back into place. Unit is
ready for testing.
Items Needed:
• Live analog phone line
• Drill
• Drill bit or knockout set
• Biscuit jack
• Mounting screws
• #10 spanner bit (provided)
• Conduit with water tight connector
• Screwdriver
• Mounting feet (provided)
2400-886DA
Items Needed:
• Live analog phone line
• Female RJ11 wall plate
• Screwdriver
646POOL, 610POOL
610POOL
646POOL
Page 5
Installation:
1. On the back of the unit, plug the line cord into female RJ11 wall plate.
2. Phone should slide onto wall plate and clip itself into place.
3. Phone is preset to dial 911. If required to call an alternate number not given to RATH® at time of purchase, please
follow programming instructions on page 6-7. If phone is calling 911, screw internal plate back into place. Unit
is ready for testing.
Note:
To open unit up for programming, use a small flat head screwdriver to gently lift the plastic covering window
on the front of the unit. Lift the logo after plastic is removed. Use a screwdriver to remove the 2 screws. Once
screws are loosened, gently lift up and out the red plastic housing on the underside of the phone. The red housing
should come off completely exposing the keypad.
