Phone Programming
1.
You can program the phone on-site or remotely.
Note:
Cellular and 900 MHz applications cannot be remotely programmed.
2.
If programming on-site, remove 12 security screws from unit, remove top cap, and pull front assembly
away from back unit.
3.
Remove the cover of the NEMA 4 enclosure by loosening the 4 corner screws.
Keypad
Page 8
On-Site Programming:
Remote Programming:
Step 1: To Begin Program Mode
A. Press
Enter
Step 2: To Program Emergency Numbers
A. Press
1, Enter
, (phone number),
Stop
Note:
Press 2-5 in step 2A for emergency numbers 2-5 as needed
Step 3: To Program Location Message
A. To turn on message Press
1, 3, Enter, 2
B. Press
6, Record
(speak message)
Stop
(to replay message
Press 6, Play
)
C. For no message Press
1, 3, Enter, 0
Step 4: To Program Auto Disconnect Time (Default is 5 minutes, lowest interval is 1 minute)
A. Press
8, Enter,
(3 digit number in minutes)
Ex:
2 minutes = 002
Step 5: To Exit Program Mode
A. Press
Stop
for 3 seconds
Step 1: To Begin Program Mode
A. Call into phone by dialing the number of the Call Station
B. After first simulated ring, Press
#, #
(Wait for 4 tones)
C. Key in security code (Default is 1111) (Wait for confirmation tones)
Step 2: To Program Emergency Numbers
A. Press
1, *,
(Phone number),
*, #
(Wait for confirmation tones)
Note:
Emergency numbers (2-5) repeat step 2A pressing (2-5) as needed
Step 3: To Program Location Message
A. To turn on message press
1, 3, *, 2
(Wait for confirmation tones)
B. Press
6, *
, (Speak message)
#, *, #
(Wait for confirmation tones)
i. To replay message Press
6, #
(Wait for confirmation tones)
C. For NO message Press
1, 3, *, 0
(Wait for confirmation tones)
Step 4: To Program Auto Disconnect Time (Default is 5 minutes, lowest interval is 1 minute)
A. Press
8, *,
(3 digit number in minutes)
Ex:
2 minutes = 002
Step 5: To Exit Program Mode
A. Press
*, #, 0
(You will hear a beep, beep)
*, #
(You will hear a buzz)
*RATH® recommends the Call Station be tested on a regular basis to ensure proper operation.
