Communication
To connect your analog phone line to the Emergency Call Station:
1.
Remove front Stainless Steel plate using the security torx bit to remove the 6 security screws.
2.
Locate the gray phone cable coming out of the NEMA 4 box.
3.
Connect the incoming phone line by connecting the tip and ring of the phone line to red and green of
provided gray line cord.
Landline:
VoIP & Wi-Fi VoIP:
See additional manual.
Page 6
Adjusting the Photocell (If Equipped):
1.
Slide the cover to the proper position on the photocell in order for the blue light to be lit at the proper time
(see drawing below). The cell may need to be partially covered if the Call Station is near a light source.
Solar Panel Wiring and Testing:
1.
Remove security screws, top cap, and pull front of the Call Station enclosure down.
2.
Remove the cover of the NEMA 4 enclosure by loosening the 4 corner screws.
3.
Locate the Sun Saver in the NEMA 4 enclosure (see drawing below).
4.
Using a voltmeter, check each set of terminals for Solar, Battery, and Load. The voltage should measure
between 12.6 and 13.8 volts on each set. If voltage is low, recheck connections.
Sun Saver
Photocell
Cover
