RASOR SW12SM, Руководство пользователя

Страница: 11 / 16

If the blade is no more able to cut (even after repeating
the sharpening operation several times) it is necessary to
replace it. To carry out this operation, use butterfly wrench
“1” and drift “3” locking the blade (shown in picture 15).
To replace the blade, proceed as follows:
1) Use some protective gloves in compliance with
Italian Legislative Decree 81/08;
2) Remove the fixed rear safety protection “A” (see
picture 16) by unscrewing the three cross-slotted
screws “C”, “D” and “E” by means of the proper
screwdriver (not supplied by the manufacturer) as
shown in picture 17. Remove the movable front
safety protection “B” (see picture 16) by unscrewing
pin “F” and the two washers “G” as shown in picture
17.
3) Insert drift “3” (see picture 15) into hole “H”, so as
to lock the blade (the hole on the blade must
correspond to the one on the structure).
4) Use butterfly wrench “1” to unscrew nut “L” and
remove blade “M” (see picture 18).
5) Replace the worn blade with the new one “2”,
being careful to center the blade on the shaft in
the correct position; we remind you to assemble it
so that the side with the writing Rasor can be seen
by the operator.
6) Assemble all the components again and carry out
the sharpening.
15. BLADE REPLACEMENT
1
15
B
A
17
E
G
H
M
1
L
18
3
2
F
C D
16
Enfocus Software - Customer Support
EN
27