EN
11
If the blade is no more able to cut (even after repeating
the sharpening operation several times) it is necessary to
replace it. To carry out this operation, use butterfly wrench
“1” and drift “3” locking the blade (shown in picture 10).
To replace the blade, proceed as follows:
1) Use some protective gloves in compliance with Italian
Legislative Decree 81/08;
2) Remove the fixed rear safety protection “A” (see
picture 11) by unscrewing the cross-slotted screw
“C” and the cross-slotted screw “D” by means of
the proper screwdriver (not supplied by the
manufacturer) as shown in picture 12. Remove the
movable front safety protection “B” (see picture
11) by unscrewing pin “E” and the two washers
“F” as shown in picture 12.
3) Insert drift “3” (see picture 10) into hole “G”, so as
to lock the blade (the hole on the blade must
correspond to the one on the structure).
4) Use butterfly wrench “1” to unscrew nut “H” and
remove blade “L” (see picture 13).
5) Replace the worn blade with the new one “2”,
being careful to center the blade on the gear, in
the correct position; we remind you to assemble it
so that the side with the writing Rasor can be seen
by the operator.
6) Assemble all the components again and carry out
the sharpening.
14. BLADE REPLACEMENT
11
B
A
10
1
2
3
12
C
D
F
G
L
1
H
13
E
Содержание FP120M
Страница 1: ...PNEUMATIC CUTTING UNIT USE MANUAL FP120M...
