嵌
入
式
蒸
氣
焗
爐
Built-in
Steam
Grill
Oven
– 24 –
– 25 –
6. Suggested to clean the water tank at least once a week. Pull out the tank horizontally, if
necessary, and use soft cloth to clean the tank. Put the tank back after cleaning.
7. Do not use a steam cleaner to clean the appliance.
8. Clean the rubber sealing of the oven door with soft cloth frequently.
9. With electricity disconnected, use soft cloth to clean the control panel if it gets wet. Make
sure do not use abrasive detergent to clean instead.
10. Disconnect the power and clean the oven cavity if the appliance will not be used for a long
time. Store it in a ventilating environment without corrosive gas.
11. If the appliance is out of service send to Shun Hing Electric Service Centre Limited for checking
and repair.
12. Clean the food tray, oil tray and grill rack with soft material (e.g. cloth) instead of hard
material (e.g. metal types) to avoid scratches on trays or damage of protective coating.
13. Never use toxic or corrosive cleaner for cleaning.
14. After cleaning, accessories must be completely dry before plugging in the power plug.
15. The appliance must be completely cooled down and cleaned before storage. Store it in a
carton and place it in a dry environment.
16. Never wrap the power cord around the appliance or place any object above the cord, as it
may cause damage and rupture the cord.
CAUTION: Do not clean the appliance with strong detergent, thinner, gasoline, abrasive powder
or metal brush. If there is an odor accumulated inside the oven after a long-time usage, put 5-6
slices of lemon in the cavity and select Steam ( ) mode at 110°C for 15-20 minutes to remove
the odor.
Application of descaling function
After using for a period of time, to prevent the accumulation of scale in the evaporator and
the hose affecting the heating performance of the appliance, it is recommended to use the
descaling function regularly to remove the scale in the evaporator and the hose. Procedures are
as follows:
1. Fill the water tank with clean water and descaling agent. (Taking citric acid as a descaling
agent as an example, add 20g citric acid per 1 liter of water.)
2. Under function selection mode, press the [ ], [ ] or [ ] button to select < Descaling>
function, and the ( ) icon will flash. Press [
] to confirm, the preset operating time
and temperature will be shown on the display. The appliance will start to operate.
3. The descaling function can be roughly divided into 3 stages (including water filling, immersion
and boiling water procedures) and two cycles; the first cycle will be completed in about 25
minutes while the second cycle will start immediately. Until the entire descaling function is
completed, it takes about 50 minutes.
4. After completion, “beep” signal sounded and the display will show "End", representing
that the descaling function has been completed.
5. Open the oven door to dissipate heat (
ATTENTION! Watch out of steam
). After the appliance
is cooled down completely, clean and dry the accumulating water and the cavity with a
damp cloth, and drain the remaining water from the water tank. The appliance can be used
again.
