Rasmussen RF-RF-LD30/36-VEI-N/P Скачать руководство пользователя страница 1

1

 

 

REV RFLD. 

Last Printed. 9/9/2020 8:52 AM 

ATTENTION! READ INSTRUCTIONS CAREFULLY BEFORE ASSEMBLY OR USE 

12028 E. PHILADELPHIA ST.  

WHITTIER, CA  CALIFORNIA  90601   U.S.A.  

www.rasmussen.biz 

WARNING 

This is a vented gas appliance for use only in a solid-fuel burning fireplace constructed on non-combustible material 

with a fully functional chimney flue which must vent all of the products of combustion.  

WHEN OPERATING, THE CHIMNEY DAMPER MUST BE FULLY OPEN  

Models; RF-LD 

30/36, 42/48, 60/72 

 VEI-Natural Gas (-N) or Propane (-P) 

18”        

Manzanita, LoneStar, CrossFire, Prestige Oak, Birch, Frosted Oak. 

20”/21” 

Evening Prestige, Evening Desire, Evening CrossFire, Evening Campfire, Evening LoneStar, CrossFire and  

             TimberFire 

24”       

Frosted Oak, Birch, Prestige Oak, CrossFire, LoneStar, Manzanita, TimberFire, Evening Lone Star, Evening  

             Prestige, Evening Desire, Evening CrossFire, Evening Campfire. 

30”       

Frosted Oak, Birch, Prestige Oak, CrossFire, LoneStar, Manzanita, TimberFire, Evening Lone Star, Evening  

             Prestige, Evening Desire, Evening CrossFire, Evening Campfire.

 

 

Do not store or use gasoline or other flammable 

vapors and liquids in the vicinity of this or any other 

appliance. 

 

 

WHAT TO DO IF YOU SMELL GAS

 

• 

Do not try to light any appliance. 

• 

Do not touch any electrical switch; do not use 

any phone in your building. 

• 

Immediately call your gas supplier from a neigh-

bor’s phone. Follow the gas supplier’s 

 

instructions. 

• 

If you cannot reach your gas supplier, call the fire 

department.

 

 

 Installation and service must be performed by a  

qualified installer, service agency or the gas  

supplier

.

 

WARNING: If the information in this manual is not  

followed exactly, a fire or explosion may result caus-

ing property damage, personal injury or loss of life. 

This appliance may be installed in an aftermarket,  

permanently located, manufactured (mobile) home, 

where not prohibited by local codes.

 

 

This appliance is only for use with type of gas  

indicated on the rating plate.  

 

INSTALLER: Leave this manual with the appliance. 

CONSUMER: Retain this manual for future reference

Installation must conform with local codes or, in the  

absence of local codes, with the National Fuel Gas 

Code, ANSI Z223.1/NFPA 54. 

Improper installation, alteration, service or 

maintenance can cause property damage, personal 

injury or loss of life. Read these instructions 

thoroughly before installation. For assistance or 

additional information, consult your gas log dealer, 

qualified installer, service agency or gas supplier. 

In the Commonwealth of Massachusetts: 

• 

Installation must be performed by a licensed plumber or gas fitter. 

• 

The chimney flue damper, when used with gas logs, will be welded open or completely removed. 

• 

A CO detector shall be installed in the room where the appliance is installed. 

MINIMUM FIREPLACE FLUE REQUIREMENTS 

The minimum permanent free opening of the fireplace chimney or chimney damper must be at least the minimum 

chimney area shown on the chart on page 6, based on a minimum chimney height of at least 8 feet. The area of the flue 

must not be less than 1/10 the area of the fireplace opening. 

The flue must exhaust all products of combustion. 

WARNING: Failure to position the parts in accordance with the diagrams in this manual or failure to use only 

parts specifically approved with this appliance may result in property damage or personal injury. 

The installation and the provisions for combustion and ventilation air must conform with 

The National Fuel Gas 

Code ANSI Z223.1 / NFPA54

, or 

The CSA B149.1, Natural Gas and Propane Installation Code, 

latest edition.

 

RF-LD Multi-Burner 

 

DECORATIVE VENTED GAS LOG SET (Electric Ignition)

 

General Assembly, Installation, and Operation Instructions 

Owner’s Manual

 

Report #10-40 

Содержание RF-RF-LD30/36-VEI-N/P

















Отзывы: