ALL APPLICATIONS (VENTED and VENT FREE OPERATION)
IMPORTANT NOTICE
•
Due to high temperatures, the appliance should be located out of traffic and away from
furniture and draperies.
•
Children and adults should be alerted to the hazard of high surface temperature and should
stay away to avoid burns or clothing ignition.
•
Young children should be carefully supervised when they are in the same room with the
appliance.
"WARNING: Any change to this heater or its controls can be dangerous."
•
Do not place clothing or any other flammable material on or near the appliance.
•
Any safety screen or guard removed for servicing an appliance must be replaced prior to
operating the heater.
•
Installation and repair should be done by a qualified service person. The appliance should
be inspected before use and at least annually by a professional service person. More
frequent cleaning may be required due to excessive lint from carpeting, bedding material,
etc. It is imperative that control compartments, burners and circulating air passageways of
the appliance be kept clean.
"WARNING: Failure to keep the primary air opening(s) of the burner(s)
clean may result in sooting or property damage."
•
Do not use this CHILLBUSTER as a Vent Free Heater in sleeping quarters, bathrooms or
recreational vehicles.
•
Keep burner and control compartment clean. See page 10 of these instructions.
•
Any outside air ducts in the fireplace shall be permanently closed at time of installation.
•
This appliance may be installed in an after market, permanently located, manufactured
(mobile) home, where not prohibited by local codes.
•
This appliance is for use with the type of gas indicated on the rating plate. This appliance is
not convertible for use with other gases.
.
IMPORTANT INFORMATION
1.
This CHILLBUSTER is for installation only in a solid-fuel burning fireplace or listed ventless firebox enclosure.
2.
Solid fuels shall not be burned in a masonry or UL 127 factory builtfireplace where a CHILLBUSTER is installed.
3.
The minimum size (in inches) of the fireplace in which this CHILLBUSTER is to be installed must be as follows:
S E T
S I Z E
M O D E L
NUMBER
FRONT
WIDTH
HEIGHT
D E P T H
18
24
30
18
24
30
18
24
30
18
24
30
(K,W,KW)(18)-C1C-(M, S, R)-(N,P) 23,000 BTU/HR
(K,W,KW)(24)-C1C-(M, S, R)-(N,P) 23,000 BTU/HR
(K,W,KW)(30)-C1D-(M, S, R)-(N,P) 23,000 BTU/HR
(K,W,KW)(18)-C1A-(M, S, R)-(N,P) 40,000 BTU/HR
(K,W,KW)(24)-C1A-(M, S, R)-(N,P) 40,000 BTU/HR
(K,W,KW)(30)-C1B-(M, S, R)-(N,P) 40,000 BTU/HR
DF(K,W,C)(18)-DFC1C-(M, S, R)-(N,P) 23,000 BTU/HR
DF(K,W,C)(24)-DFC1C-(M, S, R)-(N,P) 23,000 BTU/HR
DF(K,W,C)(30)-DFC1C-(M, S, R)-(N,P) 23,000 BTU/HR
DF(K,W,C)(18)-DFC1-(M, S, R)-(N,P) 40,000 BTU/HR
DF(K,W,C)(24)-DFC1-(M, S, R)-(N,P) 40,000 BTU/HR
DF(K,W,C)(30)-DFC1-(M, S, R)-(N,P) 40,000 BTU/HR
24
30
36
24
30
36
24
30
36
24
30
36
17
17
17
17
17
17
17
17
17
17
17
17
11
11
11
11
11
11
16
16
16
16
16
16
4. When operated as a VENT FREE heater, the minimum clearances from the fireplace opening to combustible
materials must be maintained as outlined in section "CLEARANCES TO COMBUSTIBLES" (page 5).
5.
A fireplace screen must be in place when the CHILLBUSTER is in operation and, unless other provisions for
combustion air are provided, the screen shall have opening(s) for introduction of combustion air. Glass doors are not
certified with the CHILLBUSTER. However, if used, Glass Doors must be wide open when the burner is on
to allow air for safe combustion, cooling of components and venting. Adequate clearances must be provided around
fireplace opening for adequate combustion and proper operation.
6.
The minimum inlet gas supply pressure for the purpose of input adjustment shall be 5 inches of water column on
natural gas and 11 inches of water column on Propane gases.
7.
The maximum inlet gas supply pressure shall be 7 inches of water column on natural gas and 14 inches of water
column on Propane gases. The Propane source must be regulated. Never connect CHILLBUSTER directly to an
unregulated Propane tank.
8.
The installation and the provision for combustion and ventilation air must conform with the National Fuel Gas Code
ANSI Z223.1 latest edition. S e e "
PROVISIONS FOR ADEQUATE COMBUSTION AND VENTILATION AIR"
(pages 4 and 5).
2
