7
INST
ALLA
TION
LOCATION AND MOUNTING
Treatment Unit:
WARNING:
Do not locate in an area where ambient
temperature exceeds 120
o
F (49
o
C)
.
1. Locate top of treatment tank at or below
discharge of toilet and within six feet (1.5 m)
of toilet.
Note:
Longer runs require additional flush time to
avoid sewage laying in the hose.
Note:
If mounting treatment tank higher than
discharge, a vented loop must be used between
toilet and Treatment Unit.
2. Make and secure mounting frame to flat
surface. (FIG 5)
3. Secure tank to frame using 3/4” (1.9 cm)
mounting straps.
Note:
Placing a 3/8” (.9 cm) rubber pad under tank
will help to reduce vibration and noise.
Control Module :
Note: Wires supplied are 6 feet between tank and
control module
1.
Locate control module between Tablet Dis
-
penser and Treatment Unit. Vertical mounting is
recommended (FIG 6)
2. Using screws secure manifold to the wall (FIG 6)
Switch Panel:
Cable Supplied is 16 feet
1. Locate in head compartment where indicator
lights will be visible.
2. Using base plate, mark the cutout for the panel.
(See FIG 7)
3. Route cable between switch panel and
PURASAN
®
EX
Control module.
4. Attach cable to back of switch panel.
5. After wiring and testing entire system:
Mount panel using 4 screws. Apply a bead of
nonpermanent sealant around rear edges of
panel if located in shower area.
PURASAN
®
EX Tablet Dispenser
1. Locate tablet dispenser in a location where
refill of tablet is convenient. (To easily remove
lid and refill tablets a clearance of 8” from top
of lid is recommended.)
2. Attach to wall or suitable structure using 1/4”
(6 mm) bolts.
NOTE:
Do Not load tablets into Tablet Dispenser
at this time. Load tablets after completing start
up procedure.
Size for panel
FIG 7
2 1/4” (57mm)
5/64” (2 MM)
FIG 6
Treatment Unit Mounting
14 1/8”
(35.9cm)
Mounting Frame*
1” (2.5cm)
Mounting
Straps - not included
INTAKE
DISCHARGE
1” (2.5cm)
7”
(17.8 cm)
Crossover Plug
FIG 5
Control Module
Air pump
Water valve
L519 _0815jlc
