Raritan DOMINION SX -, Инструкция по установке и эксплуатации

Страница: 94 / 172

84 D
OMINION
SX I
NSTALLATION AND
O
PERATIONS
M
ANUAL
Note: If the user issues the command lpa enable AFTER changing the default port speed, the next time the
command lpa enable is used without the optional port speed parameter, the port speed last set, e.g., 38400,
will be used as a default; to override it, enter the lpa enable command with the new port speed explicitly
specified, e.g., lpa enable 9600
Name
reset
Description
reboots unit, which may be required after some configuration changes, and may also be used to log-off all
users
Service (Telnet and SSH) Configuration
IMPORTANT NOTE : Telnet service should only be enabled when Dominion SX server’s default TCP
port is NOT set to 23, otherwise the unit will become unresponsive to http and ssh clients. If the unit is
currently set to port 23, please change it to 2200-2400 range BEFORE enabling Telnet. For Dominion
SX units that are already running firmware version 2.2.4 or higher, the default port is 51000 and
telnet can be enabled at any time.
Note : The Dominion SX system must be restarted for changes to the service configuration to take effect.
To check what port the unit is currently installed on, please log into the unit using a browser, and click on
the Configuration button on the left hand side of the screen. Sample output is shown below:
System Time: Fri Jul 16 16:25:41 2004
Ethernet Address: 00:60:e0:81:40:a8
Network Configuration:
Address IP: 192.168.51.227 (C0A833E3)
Subnet mask: 255.255.255.0 (FFFFFF00)
Gateway: 192.168.51.137 (C0A8337E)
Port Address: 2300

This is the port number
Name
service [< telnet|ssh > < enable|disable >]
Description
Configure the SSH and Telnet access.
service
With no parameters, the current service configuration is displayed.
service telnet < enable|disable >
Depending on the parameter, enable or disable telnet access.
service ssh < enable|disable >
Depending on the parameter, enable or disable SSH access.