Rapid Spray Fire Fighting Unit Operators Handbook
Rapid Spray Equipment by Rapid Spray
REVA 19/03/2019
9
CONTENTS
•
6m x 38mm suction hose
•
Camlock fittings
•
Foot strainer
Aussie Pumps are designed for sucking water directly out of dams or water sources. The
bottom fill kit is a quick, environmentally safe way of sucking up water to fill the water tank.
WARNINGS
Do not change hoses while engine and pump are operating. Observe all precautions
listed in Fire Fighter Operator Manual. Be aware of hazards working near water sources
particularly dams and rivers – slipping, falling, drowning and use safe work practices at all
times.
OPERATION / PROCEDURE
BOTTOM FILL KIT
1.
Turn off engine.
2.
Remove camlock cap from large outlet on
pump - refer to visual.
3.
Detach the suction hose from pump and
attach to top outlet - refer to visual
4.
Attach suction hose from bottom fill kit to
suction point of pump - refer to visual.
5.
Place foot strainer and hose into water
source - ensure the strainer is in clean water
free of sludge or debris.
6.
Open ball valve at bottom of tank.
7.
Start engine and operate until tank is full.
NOTE:
Rapid Spray recommend removing /
opening tank lid while filling tank.
8.
When tank is full engine off, close valve at
bottom of tank and reverse steps 4 to 2 and
unit is ready to use.
