Ransomes Spider ILD02, Руководство по безопасности, эксплуатации и техническому обслуживанию

Страница: 79 / 92

GB-35
SAFETY, OPERATORS & MAINTENANCE MANUAL
11 MAINTENANCE & LUBRICATION
11.10 FINAL GEAR DRIVE TO WHEELS
If you do not possess necessary equipment and
skills, have this work performed by an authorized
service/dealer
Remove the cover of the final gear drive. The cover is
attached by bolts onto the sides. Adjust the chain
tensioner C so the chain is properly tensioned. The
tensioner can be shifted after loosening the fastening
screws (see the figure). To tighten the chain, slightly
unscrew the thrust bolt D.
Do not tension the chain excessively. This could
reduce the durability of the chain and the bearing.
Lubricate the chain by spraying it with lubricating oil.
11.11 MAINTAINING ELECTRIC CIRCUITS
AND DEVICES, TRANSMITTER
Keep all parts of electric circuits clean, especially
from oil products, dust sediments and dry grass.
Replace conductors with damaged insulation. For
replacement use only original conductors supplied
by the manufacturer.
11.12 ADJUSTING BLADE DECCELERATION
The electromagnetic clutch is placed under the
clutch cover above the rotary blades. The clutch was
adjusted by the manufacturer. When engaged the
clutch transmits power onto the blades, when
disengaged the brake stops the rotating blades.
Do not change the clutch setting. If damage on this
part of the machine should occur, always leave the
repairing to an approved dealer. The maximum run-
down time of the rotary blade was set to 5 seconds.
NOTICE :
After finishing any work on the
electromagnetic clutch, the cover must be
returned to its original place and properly
sealed to prevent the clutch from getting dirty.
11.13 CHAINS
STEERING CHAIN
Check the wear and tension of the chain and the
tensioning devices. The chain can by tightened by
rotating the steering motor bracket after loosening
two attachment bolts
NOTICE :
Repairing of electric circuit should only be
performed by an approved dealer.
C