MAINTENANCE
14
STORAGE
If the chipper will not be used for a long period of time, we advise to:
1. Wash the machine accurately and dry it.
2. Check out all equipment and replace damaged or worn parts.
3. Tighten strongly all bolts and nuts (See torque specif cations chart).
Make an accurate greasing and at last protect the whole machine with a tarpaulin in a building. Store it
in a dry place. Following the instruction will allow you to f nd the chipper always in good conditions
whenever you use it.
MAINTENANCE
Maintenance is a fundamental operation to extend life and performances of any agricultural implement;
taking care of the machine grants you not only a good work condition, but also a longer life of the equip-
ment and greater safety in the workplace.
The operating times indicated in this manual have just an informative character and are referred to nor-
mal conditions of use; they can thus undergo variations according to the type of service, to the more or
less dusty environment, to seasonal factors, etc.
LUBRICATION
●
Grease points - use high quality lithium based grease
●
Hydraulic reservoir - use 30 weight hydraulic oil
MAINTENANCE SCHEDULE
E
VERY
10 H
OURS OF
W
ORK
- At the end of every working day it is advisable that you clean accurately the machine so that
its parts are always in good working condition.
- Grease crosses on the PTO shaft.
- Make a general inspection to verify possible hydraulic oil leaks or the presence of damaged
parts, when it applies.
- Make sure the knives are in good condition, sharpened and perfectly f xed by the tightening
bolts.
- Inspect the feed roller and clean it from the trapped wood.
E
VERY
25 H
OURS OF
W
ORK
- Grease the driveshaft crosses through the special lubricating zerks.
- Grease the transmission shaft through the proper lubricating zerks.
- Grease the bearings supporting the feed roller through the appropriate grease zerks.
Содержание 520
