-6-
WARNING: Never leave the heater unattended while operating.
Disconnect the heater from its power source when not in use.
TO ATTACH THE GUARD
1. Remove the screws from the upper shell and set aside.
2. Align the holes in the Guard with the holes in the upper shell as
shown.
3. Secure the guard to the upper shell by inserting and tightening the
screws.
TO ATTACH THE INTERCEPTOR
1. Remove the screws from the lower shell and set aside.
2. Align the holes in the Interceptor with the holes in the lower shell
as shown.
3. Secure the Interceptor to the lower shell by inserting and tightening
the screws.
ASSEMBLY
GUARD ASSEMBLY (FOR CANADA ONLY)
FOR MODELS R45K AND R75K ONLY
1. Align the holes in the upper housing with the two mounting holes on the handle
as shown.
2. Secure handle through holes provided.
Screw
Handle
Interception
Guard
Interception
Guard
Handle
Air
Inlet
Fuel
Tank
Flange
Axle
Wheel
Wheel
Support
Frame
Thermostat
Knob
Handle Installation R45K / R75K
Models R125K / R175K / R215K
FOR MODELS WITH WHEELS
These models come complete with
wheels and handles. Wheels, handles
and mounting hardware are located in
the shipping carton.
1. Loosely secure the Axle Bracket
to the Wheel Support Frame.
2. Slide the axle through the Axle
Bracket.
3. Install the wheels on the axle,
with the valve facing outward.
4. Place the flat washers and
fastening nut on the axle ends.
5. Tighten the Axle Brackets.
6. Position the Height Adjustment
Pipe to align the hole as shown.
7. Insert and tighten the bolt (M8).