Ranger INTELLISCAN SIX ZONE, Инструкция оператора

Страница: 18 / 20

18
steel ball bearing. If an OTP is used, hold it consistently in a barrel down butt right
orientation. Pass the chosen object through the left, center and right sectors of each zone
and check that consistent detection is achieved. If non-uniformity exists, adjust zone
sensitivities using the following procedure:
14.1) For Zone settings go to Zone settings and press ENT. Adjust each Zone for best
detection.
14.2) For individual Zone adjustments go to HAGC and select from Zone A1 to B6.
Zone A1 to A6 is the left side facing the metal detector from the front. Zones B1 to B6 is
the right side panel.
15.0 SUPPORT FLOORS WITH EXCESSIVE STRUCTURAL STEEL
Excessive amounts of structural steel in floor or ceiling can render a conventional
detector inoperable. Multi-zone detector is designed to scope. This changes situation
sometimes exist in building that have extra steel reinforcing to support upper level
parking. Other examples are buildings that have been designed to withstand an explosive
blast.
If a floor contains excessive amount of metal the weapon or test object will not be
detected at ground level. It may be possible to achieve detection by simply increasing the
sensitivity of Zone 6 to a high positive value. Incrementally increase Zone 6 sensitivity in
5% steps and check if weapon/ test object is detected at each step.
16.0 HORIZONTAL AXIS GAIN CONTROL
Section 14 and 15 describe how zone sensitivities can be precisely adjusted to
compensate for magnetic field distortions caused by structural steel in support floor.
Adjust the Zone sensitivities is equivalent to applying vertical axis gain control. Similar
distortions occur in the horizontal axis if the detector is positioned close to a steel support
beam or furniture made from metal. The external metal causes the detection response to
be increased on the side of the archway near the metal and to be decreased on the
opposite.
Note ideally, the best solution is to operate the detector away from external metal
object; however, not all security locations permit this.
17.0 ADVANCED FEATURES: DETECTION ENHANCEMENT OPTION
Intelliscan is equipped with a metal identification function ( IDC ) and Equalization
Channels that can selectively manipulate the detection response of specific metal objects