Rangemaster Classic Deluxe 110 Dual Fuel, Руководство пользователя

Страница: 34 / 40

WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
32
A
B
C
ArtNo.311-0010 Injectors
Fig.8-1
A – Jet, B – Internal injector, C – External injector
ArtNo.311-0011 Fitting the top panel
1 2 3
Fig.8-4
Fig.8-5
Check the technical data section at the back of the book
that the hob is convertible to the gas you want to use.
A suitably competent person must perform the conver-
sion. After conversion the installation must comply with the
relevant regulations and the local electricity supply company
requirements. Read the instructions before converting this
appliance.
nn
Failure to convert the appliance correctly could
invalidate any warranty or liability claims and lead
to prosecution.
When servicing or replacing gas-carrying components
disconnect from the gas supply before starting operation.
Check the appliance is gas sound after completion.
DO NOT use reconditioned or unauthorised gas controls.
Disconnect from the electrical supply before servicing.
Before electrical reconnection, check the appliance is
electrically safe.
Injectors
Remove the burner caps and heads. Remove the old jets
(Fig.8-1)
. Fit the new jets (see ‘ Technical Data ’ section at the
back of the book for correct jets and settngs ). Reassemble in
the reverse order.
Tap Adjustment
Pull off all the control knobs. Open the grill and right hand
oven doors and remove the four fixing screws underneath the
control panel.
Remove the handrail by removing the two end bracket fixing
screws (Fig.8-2) . Remove the two cross-headed screws that
were hidden by the handrail end brackets
(Fig.8-3)
.
The control panel should drop down slightly. It is held at
the top by two holes on the top edge, one at each end, that
locate onto tags on the inner panel. Clear the holes from the
inner panel and pull the control panel forward (Fig.8-4) .
Take care not to damage or strain the wiring.
To convert to another gas
Unscrew the tap bypass screw (Fig.8-5) . Using a pair of long
nose pliers carefully remove the bypass screw and fit the
correct replacement screw. Tighten the screw down.
Refit the control panel. Locate the holes in the top edge on
the tags on the inner panel and replace the fixing screws in
the bottom edge.
Stick on label
Stick the LP gas label over the natural gas part of the appli-
ance data label.
Pressure Testing
Connect the appliance to the gas supply. Check the appliance
is gas sound (refer to ‘
Pressure Testing ’ earlier in the book).
After checking the pressure, turn off the taps and replace the
burner head.
Reassemble burner top, making sure it is reassembled in the
correct way on the burner body.
8. Conversion to LP gas
ArtNo.210-0006 - Classic fitting the handles 2
Art No 215-0028 - Handrail fascia fixings
Fig.8-3
Fig.8-2