Rangemaster Classic Deluxe 110 Dual Fuel, Руководство пользователя

Страница: 31 / 40

INSTALLATION
Check the appliance is electrically safe when you have finished.
29
Gas Connection
This must be in accordance with the relevant standards.
The flexible hose (not supplied with the cooker) must be
in accordance with the relevant standards. Hoses may be
purchased at most builders’ merchants.
The gas supply needs to terminate with a down facing
bayonet.
The connector is located just below the hotplate level at the
rear of the cooker. If in doubt contact your supplier.
The rear cover boxes limit the position of the supply point.
Because the height of the cooker can be adjusted and
each connection is different, it is difficult to give precise
dimensions.
Although a 900 mm hose can be used, a 1250 mm hose
will allow slightly more flexibility in the positioning of the
bayonet and make moving the cooker easier.
The hose should be fitted so that both inlet and outlet
connections are vertical so that the hose hangs downwards in
a ‘U’ shape.
Ideally the hose supply connection should be within the
shaded area shown
(Fig.7-15) .
In the UK:
For natural Gas, the flexible hose must be in accordance with
BS 669. For LP Gas, it should be capable of 50 mbar pressure,
70 °C temperature rise, and carry a red stripe, band or label. If
in doubt contact, your supplier.
In the Republic of Ireland:
Consult I.S. 813 for details of connection requirements.
If in doubt contact, your supplier.
Screw connect the threaded end of the hose into the gas inlet
in the underside of the connector block on the back of the
cooker.
After completing the gas connection, ensure that the cooker
is gas sound with a pressure test.
Pressure Testing
The gas pressure can be measured at one of the centre
hotplate burner injectors (not the Wok burner).
Lift off a burner head. Fit the pressure gauge to the injector.
Turn on and light one of the other hotplate burners.
Turn on the control knob for the burner with the pressure
gauge fitted to let gas through.
See the data badge for test pressures.
Turn off the burners. Make sure that you reassemble the
burner top in the correct way on the burner body.
Fig.7-15
All dimensions in millimetres