Trying Out the Instrument
R&S
®
RTM2000
40
Getting Started 1317.4710.02 ─ 05
For your convenience, you can configure print settings initially and then print screen-
shots simply by pressing the PRINT key at any time during your measurement. This
procedure is described in "Quick Access with PRINT Key" in the "User Manual".
4.8 Storing Data
After a measurement with the R&S
RTM, you can save the results for further evalua-
tion or comparison. The following kind of data can be stored:
●
Data from measured, reference or calculated (math) waveforms
●
Instrument settings
●
Mathematical equations
●
Screen displays
Waveform data and screen displays can only be stored on USB storage devices, while
the other data can be stored also in the internal storage device of the instrument.
In the following example, you will save the device settings of the current measurement,
then reset the device and load the device settings again to repeat the initial measure-
ment.
1. Press the FILE key, then "Device Settings".
2. Press "Save".
3. Press "Storage" until "Internal" is selected to save the settings on the device.
4. Press "File Name" and enter the name "Example01".
5. Press "Accept".
The device settings are stored in a file named
Example01.SET
on the device.
6. Press PRESET to reset the R&S
RTM to its default settings.
7. In order to repeat the initial measurement, load the stored device settings. Press
the FILE key, then "Device Settings".
8. Press "Load".
9. Press "Storage" until "Internal" is selected to load the settings file from the internal
storage location.
10. Select the file named
Example01.SET
using the NAVIGATION rotary knob.
11. Press "Load".
The device settings are restored, and you can repeat the initial measurement.
For your convenience, you can configure storage settings initially and then save data
or settings simply by pressing the PRINT key at any time during your measurement.
This procedure is described in "Quick Access with PRINT Key" in the "User Manual".
Storing Data
