MSRA configuration
R&S
®
FSWP-B1
55
User Manual 1177.5862.02 ─ 09
Furthermore, the [RUN CONT] key controls the Sequencer, not individual sweeps.
[RUN CONT] starts the Sequencer in continuous mode.
For details on the Sequencer, see the R&S
FSWP User Manual.
Remote command:
Single Sweep/ RUN SINGLE
After triggering, starts a single data acquisition. If the Sequencer is off, only the evalua-
tion for the currently displayed measurement channel is updated.
While the measurement is running, the "Single Sweep" softkey and the [RUN SINGLE]
key are highlighted. The running measurement can be aborted by selecting the high-
lighted softkey or key again.
Note:
Sequencer. If the Sequencer is active, the "Single Sweep" softkey only controls
the sweep mode for the currently selected channel; however, the sweep mode only has
an effect the next time the Sequencer activates that channel, and only for a channel-
defined sequence. In this case, a channel in single sweep mode is swept only once by
the Sequencer.
Furthermore, the [RUN SINGLE] key controls the Sequencer, not individual sweeps.
[RUN SINGLE] starts the Sequencer in single mode.
If the Sequencer is off, only the evaluation for the currently displayed measurement
channel is updated.
For details on the Sequencer, see the R&S
FSWP User Manual.
Remote command:
Continue Single Sweep
After triggering, repeats data acquisition without deleting the trace of the last measure-
ment. If the Sequencer is off, only the evaluation for the currently displayed measure-
ment channel is updated.
While the measurement is running, the "Continue Single Sweep" softkey and the [RUN
SINGLE] key are highlighted. The running measurement can be aborted by selecting
the highlighted softkey or key again.
Remote command:
6.7
Output settings
Access
: [Input/Output] > "Output"
The R&S
FSWP can provide output to special connectors for other devices.
For details on connectors, refer to the R&S
FSWP Getting Started manual, "Front /
Rear Panel View" chapters.
Output settings