R&S EDST300, Начало работы

Страница: 19 / 40

Preparing for use
R&S
®
EDST300
19 Getting Started 1179.5647.02 ─ 01
The right power LED is yellow. See Table 4-1 .
► Press the [Power] key.
The left power LED lights up green. The product boots.
After the instrument has fully booted, the most recently used measurement
mode is automatically started.
Using the installed battery
If the R&S EDST300 is powered using the internal battery and the batteries
become empty, the instrument switches itself off. You cannot switch it back
on until the DC power supply is connected.
See
Chapter 4.7, "Connecting to power" , on page 15.
To shut down the product
The product is in the ready state.
► Press the [Power] key.
The operating system shuts down. The LED changes to yellow.
To disconnect from power
The product is in the standby state.
The right power LED is yellow. See Table 4-1 .
► NOTICE! Risk of data loss. If you disconnect the product from power when it
is in the ready state, you can lose settings and data. Shut it down first.
Disconnect the product from the power source.
Switching on or off