R&S EDST300, Начало работы

Страница: 16 / 40

Preparing for use
R&S
®
EDST300
16 Getting Started 1179.5647.02 ─ 01
To connect the provided DC power supply
1. Plug the AC power cable of the provided DC power supply unit into a two-pin
power outlet with ground contact.
The green operating LED on the power supply unit lights up.
2. Connect the DC power supply unit to the "POWER supply" connector on the
back of the R&S EDST300 (see Chapter 5.2, "Rear panel view" ,
on page 27).
The yellow "Standby" LED on the R&S EDST300 lights up.
To connect an optional external DC power supply
1. If necessary, connect a 12-Volt to 24-Volt DC/DC converter to the DC power
supply. The supported DC range is provided in the data sheet.
2. Connect the DC power supply unit (or the DC/DC converter) to the "POWER
supply" connector on the back of the R&S EDST300 (see Chapter 5.2, "Rear
panel view" , on page 27).
The yellow "Standby" LED on the R&S EDST300 lights up.
4.8 Connecting external devices
Various interfaces for external devices are provided.
● Connecting an antenna ................................................................................... 16
● Connecting a suppressor line ..........................................................................17
● Connecting a GPS receiver .............................................................................17
● Connecting an external monitor ...................................................................... 17
4.8.1 Connecting an antenna
The standard R&S EDST300 base unit provides two receiving antenna connec-
tions ("RF1 IN/OUT", "RF2 IN", see Chapter 5.1, "Front panel view" ,
on page 20).
If the interrogator option R&S EDST-B2 is installed on the R&S EDST300, the
instrument can also provide HF output to a transmitter antenna via the "RF1 IN/
OUT" connector (see also
Chapter 5.1.4.1, "Antenna connections RF1 IN/OUT
and RF2 IN" , on page 22).
Connecting external devices